Tutorial, part 3 - Front to Back

For the PICARD VERSION, mark the center front (piece A) down to the clip point indicated on the printed pattern.

Fuse the Picard version center front knit interfacing (piece T) to the wrong side of front, centered over the cutting line and starting slightly below the collar seam allowance (approximately ½" from pattern piece neckline). The interfacing should extend a little bit past the clip point marked previously.

Clip the center front along line to approximately ⅜" above clip point, then clip diagonally the remainder of the clip length, forming a small triangle of interfaced fabric at the bottom. 

For ALL VERSIONS, sew the division shirt front (piece A) to back (piece B) at the shoulder seams. 

Press seam allowances open. 

Repeat for the other side. 

PREVIOUS: Tutorial, part 2 - Collar Assembly

NEXT: Tutorial, part 4a - Collar to Body, Zipper Trim methods 1 and 2